Here it finally is – the anthropologie inspired skirt tutorial! There are two ways to do this. One is to make the whole skirt yourself using a knit fabric, and the other is to take an existing pencil or slim a-line skirt you already have and add the ruffles to it. If you choose to do the latter, simply skip to the ruffle steps below.
What You Need:
– About a yard of knit fabric, depending on your size (see step 1 for details). This will be the main fabric – mine was grey.
– Two contrasting fabrics, about 1/4 to 1/8 each.
I made this skirt have a half lining to it because the knit was so thin. So, I had extra fabric along the inside.
Step 1: Measure around the widest part of your hips. Add 2 to that measurement. This is w. Also, measure how long you want the skirt to be, and how long you want the extra lining material to be – usually just enough to cover your rear is good- and add it to itself. This is L. Next, cut out two strips of skirt measuring L by w.
Step 2: Mark where your length measurement of the skirt ends (so you should have a mark between the extra lining fabric you added and the actual length you want your skirt to be). Fold the fabric at that point, so you wind up with a fold at the waistband, the normal skirt on one side, and the lining part on the other. Do this on both pieces of fabric, and then pin them together so the lining part is on the OUTSIDE.
Step 3: You might want to curve the top of the skirt, depending on where you want your skirt to sit. I wanted mine to sit on my waist, so I curved it along the hips a bit – with the lining still pinned and the skirt folded (because you’ll want the lining curved as well). Now, simply sew the sides together on your two pieces of fabric, and you’ll wind up with your main skirt piece. Now turn the skirt right side out, and you’re onto the ruffles!
Step 4: Cut contrasting fabric number 1 into strips that are 1.5 times as long as the skirt is around (you may need to sew multiple strips together). Gather this strip, pin, and sew along the bottom of the skirt along the right side. Don’t worry, the raw edges will be hidden by the next ruffle.
Step 5: Cut a strip of contrasting fabric #2 so that it is the same length as the skirt width (all around). Gather it, then pin it starting about 1/3 of the way away from the side seam. Pin it all around the skirt, stopping about the same distance from the seam on the back side. Sew it in place.
Step 6: Now cut a strip 1.5 times the skirt (I’m just going to call the measurement around the skirt ‘the skirt’ now… ) of the original skirt material. Pin it onto the skirt, slanting it up over the contrast ruffle you just did, like shown in the picture below. You want to make sure it still covers all of the seams of the lower ruffle but slopes up subtly. Sew it on!
Step 7: Next is another partway ruffle! Ruffle a strip of contrast #1 that is about the same length as ‘the skirt’, and sew it on starting a little closer to the side seam than the white ruffle was. Once again, slope it up so it follows the line of the previous ruffle.
Step 8: Here is your final ruffle! Get another strip of the original skirt fabric that is 1.5 times the ‘skirt length’ and ruffle and sew it around. However, this time you will pin it facing UP, as shown in the horrible blurry picture below. Make sure you pin it quite close to the previous ruffle, as it will fold over (to hide the seam) and lose some of it’s height.
Now, just flip the top ruffle down and iron. Ta da!
credits to: rufflesandrosescrafts.blogspot
No comments:
Post a Comment